top of page

Air-Saver

The best air saving solutions

Installing the AIR-SAVER is very simple and all compressed air systems can be retro-fitted with this wonderful cost saver!

The AIR-SAVER is a very cost effective tool in preventing valuable compressed air escaping unnecessarily.

untitled.png

For years the AIR-SAVER has helped end users to save valuable compressed air from escaping unnecessarily, reducing compressor running hours and thus extending its lifetime, saving energy and operating costs.

The AIR-SAVER is typically installed on the air outlet of the air receiver tank. Alternatively it is applied in larger factories to close off certain parts of the compressed air system, where during certain parts of the day no compressed air is required.

​

A typical compressed air system has air loss 24 hours per day through pipe works connections and leaking float type drains etc. By installing an AIR-SAVER the end user will limit these types of air losses to the operating hours only. At the end of the (department) working day the AIR-SAVER will close off the air flow and prevents further loss of valuable compressed air.

The new control module offers programming simplicity and new enlightened display features, offering you more visual information.

The AIR-SAVER will close off the air flow and prevents further loss of valuable compressed air.
The AIR-SAVER is typically installed on the air outlet of the air receiver. Alternatively it is applied in larger factories to close off certain parts of the compressed air system, where during certain parts of the day no compressed air is required.

Air-Saver 1"

imagegen.jpg
The AIR-SAVER is available in a 1" or 2" NPT configuration.
Call 1-855-777-4432 or click here to request a quote.

Air-Saver 2"

The AIR-SAVER is a simple timed valve that isolates your compressor and compressed air storage tank from the rest of your compressed air system. Using a programmable timer, it opens just before each shift starts and closes just after each shift ends, ensuring you never lose valuable compressed air to leaks.
​

Even if you turn your compressor off at the end of the day, leaks will consume all the air in your compressed air storage tank, requiring you to repressurize the tank again the next morning.

 

The AIR-SAVER isolates your storage tank ensuring it remains at full pressure ready for the following day, saving both time and energy.

turn.jpg
control.jpg

Features

  • No unnecessary compressor start-up during periods when compressed air is not required.

  • Just set it & forget it!

  • Compressor, dryer and filter activities are reduced during factory closing hours.

  • At least one air receiver’s worth of compressed air savings per day.

  • Possibility to shut of parts of the pipe line system where compressed air is not needed continuously.

  • Fully automatic and maintenance free design.

  • Battery saves the installation set-up during power failure.

  • Up to 230 PSI.

  • Slow valve opening to avoid hammer strike in pipe line system.

  • Time programmed or remote controlled.

  • Alkaline batteries protecting the program.

  • Micro-Processor controlled (multi cycle 7 day program).

  • Large LCD display showing program cycle and current time.

imagegen.png

Remote control option, offering you the possibility to install the AIR-SAVER at a height.

bottom of page